Characteristics of vertical crusher

The inner wall of the vertical crusher shell is lined with stainless steel, which alleviates the problem of sticking to the wall and not easy to clean up. The hammer is made of special steel forged and pressed to resist wear and corrosion, which can effectively prolong the service life and improve the production efficiency. This machine has the characteristics of reasonable structure, simple operation, strong applicability, convenient maintenance and so on.

1, Simple and reasonable structure, low operating cost. The use of stone stone principle, small wear.
2, High crushing rate, energy saving.
3, With fine crushing, coarse grinding function.
4, Affected by the water content of the material is little, less than 50 percent of the water content of the material can be crushed.
5, The working noise is lower than 75 db (DB level), less dust pollution.
6, Suitable for crushing medium and extra-hard materials.
7, The impeller lining wear is small, convenient maintenance.
8, V ertical crusher has good technology, reliable equipment quality and low energy consumption.
9, For adaptable material moisture content is higher, should not be blocked, the material flow, material from the feed port, collided with the high-speed rotation of the chain inside the casing, material after collision, squeezing and broken, and then the impact to the inner wall of the casing response and then collided with the chain, so after several impacts in the process of falling into a fine powder or 3 mm below the particles from the lower part.
10, The inner wall of the vertical crusher shell is lined with polypropylene plate, crushing materials do not stick to the wall, easy to clean.
11, Vertical crusher blade is made of special steel pole, can effectively improve the production efficiency.
12, The machine has reasonable structure, convenient operation, strong applicability.