Ten safe use skills of straw crusher

Straw crusher should be fixed on the ground, and cement can be used to fix it. If the working place is frequently changed, the crusher and motor shall be mounted on a pedestal made of Angle steel.

After the installation of straw crusher should be carefully checked whether the installation is in place, check whether the installation is not firm enough. Whether the motor shaft is parallel to the mill shaft, and check whether the tightness of the belt is appropriate.

Before starting the straw crusher, rotate the rotor by hand first to check whether the operation is flexible and normal, whether there is collision in the casing, whether the rotation direction of the rotor is correct, whether the lubrication of the motor and the crusher is good, etc.

Straw grinder should not often replace the pulley, in case the speed is too high or too low.

After the straw crusher is started, it should be idled for 2 to 3 minutes first, and then feed after there is no abnormal phenomenon.

Straw crusher feeding should be uniform, if there is noise, bearing and body temperature is too high or spraying material and other phenomena, should immediately stop the inspection, troubleshooting.

Before the work of the straw crusher, the staff should carefully check the material to prevent metal, stone and other hard objects from entering the crushing chamber and causing accidents.

When feeding, the staff should stand on the side of the straw crusher to prevent being injured by the debris bounced out. Do not hold the long stalks too tightly to prevent them from being carried in.

The straw crusher should stop feeding before stopping the machine, and then cut off the power supply to stop the machine after the materials in the standby machine are cleared. Cleaning and maintenance should be carried out after the shutdown.

After 300 hours of straw crusher operation, the bearing must be cleaned and the oil replaced; When installing oil, it is better to fill 1/3 of the gap of the bearing seat, not more than 1/2. When the machine stops for a long time, the transmission belt should be removed.