Working principle of semi-wet material crusher

Semi-wet material crusher adopts two-stage rotor up and down grinding, the material through the superior rotor grinder into fine particles, and then transported to the lower rotor to continue grinding into fine powder to achieve the best effect of material powder, hammer powder, and finally discharge directly out of the outlet.

The semi-wet material crusher does not design the screen mesh screen bottom, more than 100 kinds of materials can be crushed, never blocked. Even the material just fished out of the water can be crushed, and it will not be blocked by wet material crushing, resulting in burning out the motor and affecting production.

Semi-wet material crusher adopts high alloy wear-resistant hammer, hammer made of forging, especially strong and wear-resistant, stronger and wear-resistant than ordinary hammer, increasing the service life of the hammer.

Semi-wet material crusher adopts two-way gap adjustment technology. If the hammer is worn, it does not need to be repaired, and the position of the hammer can continue to be used. Adjusting the gap between the hammer and the lining plate can control the material size.

Semi-wet material crusher adopts high-tech technology, only one person can easily operate, not only safe and reliable, but also easy to maintain.

Centralized lubrication system oiling, under normal operation, lubricating oil can be injected without stopping.